Table of Contents
Advertisement
Basic User Operations
4. Make sure that the battery plug is connected on the rear of the UPS.
5. Power ON the UPS.
6. Power ON the printer by turning the power disconnect to ON, and then pressing the green
ON button on the front of the printer.
7. Power ON the laser by turning the key switch clockwise.
8. Power ON the scanner.
9. Power ON the PC. Wait a minimum of 15 minutes after the laser has started before
operating the system.
10. Log in to the computer. User: Operator | Password: S0l1dConcepts (2nd and 4th
characters are numbers)
Figure 2: UPS Battery Plug Location
Some printers may require the login, User: tdguser | Password: Ok4tech18 (O is
capital letter, not number)
Make sure that sleep mode is disabled on the computer to prevent laser
communication interruptions.
© Copyright 2020 Stratasys. All rights reserved.
Powering ON the Printer
Page 70
Advertisement
Table of Contents
