Table of Contents
Advertisement
Graphical User Interface
•
ReHome: Moves the elevator to the top of its travel (drain position). This button first resets
the elevator's home position, so the rehome task must be successfully completed (and not
interrupted). If the elevator is not homed, it will be unable to perform any motion tasks.
•
Move Up/Move Down: Press and hold to move the elevator in either direction. Release to
stop.
•
Move to Drain: Raises the elevator so that the platform is above the resin level and able to
drain.
•
Move to Start: Moves the elevator to the Start Position, as defined in the "Elevator Settings"
pane, on the Machine Settings screen.
•
Move Up by.../Move Down by...: Enter a positive value (in inches) in the adjacent field, and
tap either button to move the elevator up or down by the specified distance.
•
Go To...: Enter a positive value (in inches) in the adjacent field, and tap to move the
elevator to that position.
•
ReHome: Homes the recoater to the front edge of the recoater rim.
•
Move to Rear/Move to Front: Press and hold to move the recoater in either direction.
Release to stop.
•
Move to Rear by.../Move to Front by...: Enter a positive value (in inches) in the adjacent
field, and tap either button to move the recoater forward or back the specified distance.
•
Go To...: Enter a positive value (in inches) in the adjacent field, and tap to move the
recoater to that position.
Figure 25: Recoater Pane
© Copyright 2020 Stratasys. All rights reserved.
Optowave Laser Control Panel
Page 55
Advertisement
Table of Contents
