Table of Contents
Advertisement
Basic Use of SolidView Pro V650
Even on builds with many parts on the tray it is a best practice to place the parts at an angle
and space them to avoid starving the blade.
Is is also best to avoid a trapped volume of resin, as when resin is trapped it can starve the
recoater blade and cause problems with the build.
When building large parts, take care to fully support the parts and avoid part shrinking. It is also
a best practice to avoid shallow angles.
Figure 41: Multiple Part Placement
Figure 42: Avoiding Trapped Resin
Figure 43: Large Part Orientation
© Copyright 2020 Stratasys. All rights reserved.
Optowave Laser Control Panel
Page 66
Advertisement
Table of Contents
