Reset All Ip Settings; Reset To Factory Defaults - Extron electronics TouchLink TLP Pro 1220 Series User Manual

Reset All IP Settings

This mode resets all IP settings to factory defaults.
Activation
To reset all IP settings:
1.
Hold down the
at 6 seconds).
2.
Release and press
the momentary press does not occur within 1 second.
Result
Reset All IP Settings mode:
•
Sets the IP address back to factory default (
•
Sets the subnet back to factory default (
•
Sets the default gateway address to the factory default (
• Sets all other IP settings, addresses, and domain and host names back to factory default.
• Turns DHCP off.

Reset to Factory Defaults

This mode resets all IP settings and touchpanel settings to factory defaults and removes all
configurations. It allows you to start over with configuration and uploading.
Activation
To reset the unit to all factory default settings:
1.
Hold down the
again at 6 seconds, and again at 9 seconds).
2.
Release and press
the momentary press does not occur within 1 second.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except the
firmware).
• Does everything Reset All IP Settings mode does.
• Removes touchpanel user interface layout and configurations.
•
Resets all touchpanel settings to factory default.
TLP Pro 1220, TLP Pro 1520, and TLP Pro 1720 Series • Reference Material
button until the Reset LED blinks twice (once at 3 seconds and again
Reset
Reset momentarily (for <1 second) within 1 second. Nothing happens if
255.255.255.0
button until the Reset LED blinks three times (once at 3 seconds,
Reset
Reset momentarily (for <1 second) within 1 second. Nothing happens if
192.168.254.251 ).
).
).
0.0.0.0
31