Table of Contents
Advertisement
Extension Programming
[612] Data Line Security
Description
Sets or cancels the Data Line Security mode on an extension basis.
Selection
• Jack number: 1-4 (-1/-2), 5-8
• On/Off
Default
All jacks — Off
Programming
1.
Enter 612.
Display: Data Mode
2.
Press NEXT.
Display: Jack NO?
3.
Enter a jack number.
To enter jack number 1, you can also press NEXT.
To select the second part (-2), press NEXT after entering a jack number.
Display example: #1-1:Off
4.
Keep pressing SELECT until the desired selection is displayed.
5.
Press STORE.
6.
To program another jack, press NEXT or PREV, or SELECT and the desired jack
number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• For an explanation of jack numbering, see "Rotation of jack number" in Section
1.3 Programming Ways.
• To assign one part (first part or second part) of all jack numbers to one selection, press the
key at step 3. In this case, the display shows the contents programmed for Jack 1.
Features Guide References
Data Line Security
216
(-1 = first part, -2 = second part)
Programming Guide
Advertisement
Table of Contents
