Table of Contents
Advertisement
[426] ISDN TEI Mode
Description
Assigns the Terminal Endpoint Identifier (TEI) mode on ISDN port basis.
Selection
• Port number: 1-3
• Fix 0 through 63/Automatic
Default
Port 1, 2 — Fix 0
Port 3 — Automatic
Programming
1.
Enter 426.
Display: TEI Assign
2.
Press NEXT.
Display: Port NO?
3.
Enter a port number.
To enter a Port 01, you can also press NEXT.
Display example: #1 :Fix 0
4.
Enter TEI.
To change the current entry, press CLEAR and enter the new number.
To assign "Automatic", press CLEAR and do not enter the new number.
5.
Press STORE.
6.
To program another port, press NEXT or PREV, or SELECT and the desired port
number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• If the "Point" is selected in programme [424] ISDN Configuration are selected, assign the
fixed TEI. If the "Multipoint" is selected, assign "Automatic". After this assignment, you
should reset the system so that this assignment is effective.
• To assign all ports to one selection, press the
the contents programmed for Port 1.
Programming Guide
key at step 3. In this case, the display shows
CO Line Programming
159
Advertisement
Table of Contents
