Install The Gauge Wheels; Gauge Wheel Mounting Locations; Mount The Gauge Wheels - Raven AutoBoom Installation Manual

Chapter 3

Install the Gauge Wheels

Gauge Wheel Mounting Locations

Wheel mounting locations may be influenced by the boom configuration. Determine the appropriate location for
mounting the wheels on the boom, ensuring the wheels will not interfere with or be damaged while folding or
unfolding the booms. The wheels should be mounted outside of the boom fold, but inside the boom
breakaway..

Mount the Gauge Wheels

Note:
The appearance of the wheel axles may vary.
Gauge Wheel Installed
FIGURE 11.
Remove the nuts from the left wheel axle (P/N 063-0131-590).
1.
Place the wheel (P/N 322-0131-008) on the left wheel axle.
2.
Align and place the hub retainer bracket (P/N 107-0171-617) over the wheel.
3.
Reinstall the lug nuts on the wheel axle to secure the wheel and hub retainer bracket.
4.
Mount the left wheel receiver bracket (P/N 116-0159-697) to the front of the left boom by installing four
5.
1/2" ID x 3.12" L x 3/8" thread zinc plated U-bolts (P/N 435-3003-043) through the back of the receiver
bracket and securing them with eight 3/8"-16 zinc flanged lock nuts (P/N 312-1001-164).
Insert the left wheel axle into the left wheel receiver bracket, positioning it so that the bottom of the wheel
6.
touches the ground (or nearly so).
Secure the gauge wheel assembly in the wheel mounting bracket by installing two 1/2"-13 x 1-1/2" SS hex
7.
bolts (P/N 311-0058-186) and two 1/2" zinc hex nuts (P/N 312-1000-043).
Repeat the steps above to install the right wheel.
8.
16
WARNING
The machine must remain stationary and
switched off, with the booms unfolded and
supported, during installation or maintenance.
Miller Condor Spray-Air Boom AutoBoom Installation Manual
2-