Dismounting Machine From Tractor; Mounting And Adjustments; Installing Tines - SaMASZ TANGO 730 Operator's Manual

CAUTION:
Removing clogs and jams while the machine is in operation can lead to the
accident !
In case of machine blockage caused by wrapped material, set the machine on a flat surface,
remove excess material using sharp tool. After clearing the machine check if nothing has been
damaged.
To remove any clogging it is obligatory to disconnect the drive and the motor, take out the
ignition key. When eliminating any clogging on the machine, use also safety means for operator, so
protective gloves and tight wear.

5.13. Dismounting machine from tractor

NOTE:
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
Set the machine onto an even, stable ground,
Turn the tractor's ignition off and take the key out,
Secure the machine against moving by placing wedges at wheels,
Fold out the support leg and protect with safety pin,
Disconnect the machine's hydraulics and electrics from the tractor,
Disconnect control panel,
Dismount the telescopic articulated shaft and place it on the shaft holder, which is standard-
delivered with the machine,
Detach the machine from the tractor.

6. MOUNTING AND ADJUSTMENTS

6.1. Installing tines

Tines should be installed according to scheme provided in Fig. 35.
WARNING:
- Use only tines recommended by manufacturer.
- Before each operation check condition of tines and holders. Worn or
damaged tines should be replaced immediately.
Instruction manual
Fig. 35. Installing raking tines
- 25 -
Two rotor rake
TANGO