Switching Rake From Forming One To Forming Two Single Rows; Protection Mechanism Of Front Safety Curtain - SaMASZ TANGO 730 Operator's Manual

Two-rotor rake

Hide thumbs Also See for TANGO 730:

Table of Contents

get both of working assemblies as near to each other as possible (Fig. 31).

5.10. Switching rake from forming one to forming two single rows

In order to switch the machine for raking two rows, perform the following:

fold out working assemblies with tractor's hydraulics, so that raking tines on front working

assembly do not overlap with tines on the rear assembly,

open valve on tarpaulin cover mechanism cylinder.

Switching the valve shall cause the cover to get lifted as headlands with working assemblies,

and be set for operation as the machine starts raking.

When forming two rows the rear cover is set the same as when forming a single one.

Once the work is completed, first lift the tarpaulin cover mechanism (Fig. 28) and secure the

valve on cylinder (Fig. 29). Working assemblies can be slid down only when the mechanism is

secured.

NOTE:

When sliding down the working assemblies, pay particular attention to

tarpaulin cover on the front working assembly – if in lower position its

damage may follow.

The mechanism is designed to provide protection of front safety curtain against damage in the

event the curtain was not locked in the upper position by shut-off valve, and the rotating working

units will be slid down.

Instruction manual

Fig. 31. Rake set for forming one row

Fig. 32. Protection mechanism of front safety curtain

- 23 -

Two rotor rake

TANGO

Table of Contents