Removing Clogging And Jams; Dismounting Machine From Tractor - SaMASZ TANGO 730 Operator's Manual

OPERATOR'S MANUAL
CAUTION!
When preparing the rake for position for headlands, there is a risk of tilting and
falling of the aggregate, thus this should be carried out on an even ground.
When turning back, reduce the driving speed accordingly!

5.10. Removing clogging and jams

When operating the mower pay attention to variable conditions in Field, which may influence the
mower clogging and blocking, such as: terrain unevenness, height and density of grass as well as other
objects in the grass (stones, branches, piles of soil). In order to avoid clogging and blocking, operating
speed should be adjusted to the mentioned conditions.
CAUTION!
Removing clogs and jams while the machine is in operation can lead to the
accident !
In case of machine blockage caused by wrapped material, set the machine on a flat surface, remove
excess material using sharp tool. After clearing the machine check if nothing has been damaged.
To remove any clogging it is obligatory to disconnect the drive and the motor, take out the ignition
key. When eliminating any clogging on the machine, use also safety means for operator, so protective
gloves and tight wear.

5.11. Dismounting machine from tractor

CAUTION!
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
Set the machine onto an even, stable ground,
❑
Turn the tractor's ignition off and take the key out,
❑
Secure the machine against moving by placing wedges at wheels,
❑
Fold out the support leg and protect with safety pin,
❑
Disconnect the machine's hydraulics and electrics from the tractor,
❑
Disconnect control panel,
❑
Dismount the telescopic articulated shaft and place it on the shaft holder, which is standard-
❑
delivered with the machine. PTO shaft and power input ends should be protected with guards,
TWO-ROTOR ROTARY RAKE
Fig. 35. Rake in position for headlands
TANGO 730
31