Restarting The Machine After Storing Period; Dismounting Machine From Tractor - SaMASZ KW 141 Operator's Manual

OPERATOR'S MANUAL
CAUTION!
When performing repair and maintenance works the machine should be lowered
onto the ground or supported (cutterbar) onto supports ensuring its full stability,
with the tractor's engine disconnected and ignition key off.
CAUTION!
Storing the machine otherwise as given, may result in machine instability and
thus its damage.

6.8.5. Restarting the machine after storing period

After the storing period perform the following:
Make sure that all nuts and screws are tightened with correct torque (Tab. 9).
❑
Make sure that all guards are installed in place.
❑
Lubricate the whole machine.
❑
Examine condition of flail knives, and if necessary, replace them with new ones.
❑
Tab. 9. Torque values for bolts

6.8.6. Dismounting machine from tractor

WARNING!
When detaching, make sure there is no person in between the machine and the
tractor.
When dismounting machine from tractor perform the following:
turn off unloading function and do not turn it on again,
❑
open pressure reduction valve for 10 seconds and then close it (Fig. 68),
❑
lower flail head onto paved and even ground,
❑
put forth and protect support legs,
❑
dismount linkage frame (undo bolts and remove pins),
❑
take linkage pins out,
❑
lower the machine by means of 3-point linkage,
❑
REAR EXTENSION ARMS KWT, CAMEL, KOLIBER, KW, LAMA
59