Clogging; Dismounting Machine From Tractor; Mounting And Adjustments; Mounting Of The Tines - SaMASZ P4-471 Operator's Manual

5.9. Clogging

In order to avoid clogging, mowing speed should be adjusted to the mentioned conditions. In
order to remove the machine clogging, lower the cutterbar onto the ground, disconnect the drive,
take ignition key off and pay particular attention. When eliminating the tedder's clogging, use also
safety means for operator, so protective gloves and tight wear.

5.10. Dismounting machine from tractor

WARNING:
When dismounting, make sure there is no person in between the tedder and
the tractor.
To dismount the tedder from the tractor:
Set the machine onto an even, stable ground,
Support the machine with the support leg and protect with safety pin,
Turn the tractor's ignition off and take the key out,
Protect the tractor against free runaway,
Disconnect the machine's hydraulics from the tractor,
Dismount the PTO shaft and place it on a PTO shaft holder, which is standard-delivered
with the machine,
Detach the machine from the tractor.

6. MOUNTING AND ADJUSTMENTS

6.1. Mounting of the tines

The tines should be mounted according to the scheme shown in Fig. 24 and 25.
Operator's manual
Fig. 24. Mounting of the tines P4 – 471 and P4-531
Fig. 25. Mounting of the tines P6 - 651 and P6 – 771
- 23 -
Rotary tedder P4 – 471 and P4 – 531
Rotary tedder P6 – 651 and P6 – 771