Removing Clogging; Dismounting Machine From Tractor - SaMASZ Z2-780 Operator's Manual

CAUTION:
When preparing the rake for position for headlands, there is a risk of tilting
and falling of the aggregate, thus this should be carried out on an even
ground.
When turning back, reduce the driving speed accordingly!

5.8. Removing clogging

When operating the mower pay attention to variable conditions on field, which may influence the
mower clogging and blocking, such as: terrain unevenness, height and density of grass as well as
other objects in the grass (stones, branches, piles of soil). In order to avoid clogging and blocking,
operating speed should be adjusted to the mentioned conditions.
CAUTION:
Removing clogs and jams while the machine is in operation can lead to the
accident !
In case of machine blockage caused by wrapped material, set the machine on a flat surface, remove
excess material using sharp tool. After clearing the machine check if nothing has been damaged.
To remove any clogging it is obligatory to disconnect the drive and the motor, take out the ignition
key. When eliminating any clogging on the machine, use also safety means for operator, so
protective gloves and tight wear.

5.9. Dismounting machine from tractor

CAUTION:
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
set the machine on an even and stable ground,

turn off the tractor's ignition off and remove the key,

secure the machine against moving by placing wedges at its wheels,

fold the support leg and protect with safety pin,

disconnect the machine's hydraulics and electrics from the tractor,

dismount the telescopic articulated shaft and place it on the shaft holder, which is standard-

delivered with the machine. PTO shaft and power input ends should be protected with guards,
detach the machine from the tractor.

secure hitch pin with a padlock (Fig. 28).

Operator's manual
Fig. 28. Protection against unauthorized use
- 26 -
Twin-rotor rotary rake
Z2-780; Z2-840