Removing Clogging And Jams; Dismounting Machine From Tractor - SaMASZ TANGO 730 Operator's Manual

CAUTION:
When preparing the rake for position for headlands, there is a risk of tilting
and falling of the aggregate, thus this should be carried out on an even
ground. When turning back, reduce the driving speed accordingly!
5.12.

Removing clogging and jams

When operating the machine pay attention to variable conditions in field, which may
influence the clogging and blocking, such as: terrain unevenness, height and density of grass as well
as other objects in the grass (stones, branches, piles of soil). In order to avoid clogging and
blocking, operating speed should be adjusted to the mentioned conditions.
CAUTION:
Removing clogs and jams while the machine is in operation can lead to the
accident !
In case of machine blockage caused by wrapped material, set the machine on a flat surface,
remove excess material using sharp tool. After clearing the machine check if nothing has been
damaged.
To remove any clogging it is obligatory to disconnect the drive and the motor, take out the
ignition key. When eliminating any clogging on the machine, use also safety means for operator, so
protective gloves and tight wear.
5.13.

Dismounting machine from tractor

CAUTION:
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
Set the machine onto an even, stable ground,
Turn the tractor's ignition off and take the key out,
Secure the machine against moving by placing wedges at wheels,
Fold out the support leg and protect with safety pin,
Disconnect the machine's hydraulics and electrics from the tractor,
Disconnect control panel,
Dismount the telescopic articulated shaft and place it on the shaft holder, which is standard-
delivered with the machine,
Detach the machine from the tractor.
Instruction manual
A
Fig. 34. Rake in position for headlands
- 25 -
Two rotor rake
TANGO
B