a)
Fig. 27. Lock (3) blocked when taking turns over swaths a) Z2-780, b) Z2-840
In order to lift working units to transport position use the cord (4) to lift the lock during first
phase of lifting working units.
5.10. Removing clogging
To remove any clogging it is obligatory to disconnect the drive and the motor, take out the
ignition key. When eliminating any clogging on the machine, use also safety means for operator, so
protective gloves and tight wear.
5.11. Dismounting machine from tractor
CAUTION:
When dismounting, make sure there is no person in between the machine
and the tractor.
To dismount the machine from the tractor:
Set the machine onto an even, stable ground,
Turn the tractor's ignition off and take the key out,
Secure the machine against moving by placing wedges at wheels,
Fold out the support leg and protect with safety pin,
Disconnect the machine's hydraulics and electrics from the tractor,
Dismount the telescopic articulated shaft and place it on the shaft holder, which is standard-
delivered with the machine,
Detach the machine from the tractor.
6. MOUNTING AND ADJSUTMENTS
6.1. Mounting and timing of the tines
The tines should be mounted as shown in Fig. 28.
Operator's manual
4
5
3
Double – sided rotary rake
Z2-780; Z2-840
4
b)
- 20 -
3