Operating Parts; Telescopic Articulated Shaft; Hydraulic Assembly - SaMASZ TANGO 730 Operator's Manual

Fig. 5. Moving machine onto another vehicle for transport
162'' / 4115 mm

4.4. Operating parts

Prior to operating the rake check condition of both the rotor and raking tines.
Worn or damaged tines should be replaced immediately with new ones.
WARNING!
When replacing working parts, always use protective gloves.

4.5. Telescopic articulated shaft

Prior to operating learn provisions found in the shaft manufacturer's manual placed on the shaft.
Use the shafts recommended by the mower's manufacturer only.
In order to operate safely use only fully technically fit, undamaged telescopic articulated shafts.
Damaged telescopic articulated shaft shall be repaired or replaced with new one.
Before any operation make sure whether PTO rpm have proper rotational direction.

4.6. Hydraulic assembly

Note! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate
through skin and cause serious injury, therefore skin and eyes should be protected in particular.
In case of injuries caused by liquid under pressure, call a doctor immediately.
Instruction manual
Fig. 6. Location of centre of gravity
- 8 -
Two rotor rake
TANGO