SaMASZ TANGO 730 Operator's Manual page 20

S
The following should be performed in workplace and as rake is in working position:
connect PTO shaft extension onto tractor's spline shaft (if only one extension was taken out) or
connect the complete PTO shaft,
set the tractor and rake aggregate on an even, level ground,
lift or lower adjustment lever (Fig. 18) to set the required raking height. Recommended distance
of raking tines and the ground is 10 mm (Fig. 21).
NOTE!
It is forbidden to lower raking arms below 1 cm from the ground as this may
cause damages to the machine such as bending the raking arms, breaking the
linkage or the gear, faster wearing of raking tines, damaging the turf and
causing contamination to the collected forage, etc. Too high a raking set may
cause the swath not be collected completely.
NOTE!
The raking arms' height should be controlled on an on-going basis while
operating the machine, and if need be, adjusted. Adjustments are performed
with tractor's drive off.
Instruction manual
Fig. 17. Preparing drive system of the rake
Fig. 18. Raking height adjustment lever
- 18 -
Two rotor rake
TANGO
K