Clogging Of The Rake; Dismounting Machine From Tractor; Mounting And Adjustments; Tine Mounting - SaMASZ UNO 410 Operator's Manual

5.8. Clogging of the rake

In order to avoid clogging, mowing speed should be adjusted to the mentioned conditions. In
order to remove the machine clogging, lower the cutter bar onto the ground, disconnect the drive,
take ignition key off and pay particular attention. When eliminating the machine clogging, use also
safety means for operator, so protective gloves and tight wear.

5.9. Dismounting machine from tractor

CAUTION:
When dismounting, make sure there is no person in between the mower and
the tractor.
To dismount the rake from the tractor:
Set the machine onto an even, stable ground,

Support the machine with the support legs and protect with safety pin,

Turn the tractor's ignition off and take the key out,

Protect the tractor against free runaway,

Dismount the PTO shaft and place it on a PTO shaft holder, which is standard-delivered with

the machine,
Detach the machine from the tractor.

6.

MOUNTING AND ADJUSTMENTS

6.1. Tine mounting

Tines should be mounted as provided on scheme on Fig. 23.
NOTE:
Use genuine manufacturer recommended tines only.
Operator's manual
Mounting rake tines
Fig. 23.
- 20 -
Rotary rake UNO