Cisco SX350 Series Administration Manual page 702

Smart Network Application (SNA)
DAC Workflow
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
Specify a RADIUS Server and Clients
Click Edit DAC Mode in the Options
The application enters the DAC edit mode (this is indicated by the blue frame around the
topology map and the control panel on the bottom of the screen.
Select one of the SNA devices and click on its
Designate it as he RADIUS server for the network by clicking + Set as DAC server.
The following menu is displayed:
If the device has more than a single IP address, select one of those addresses as the one to be
used by DAC. The list of addresses indicates whether the IP interface is static or dynamic. You
will be warned if selecting a dynamic interface that the address may not be stable. When
editing an existing DAC server, the address currently used by its clients is pre-selected.
Enter a key string that will be used by the DAC RADIUS server with all its clients on the
network.
Click Done.
The DAC RADIUS server is highlighted in the Topology view.
menu.
menu.
29
686