Table of Contents
Advertisement
Multicast
IPv6 Multicast Configuration
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
Click Multicast > IPv6 Multicast Configuration > MLD Proxy.
Enter the following fields:
•
MLD Multicast Routing—Select to enable IPv6 Multicast routing.
•
Downstream Protection—Select to discard downstream packets not required for the
device.
•
Source Specific Multicast—Select to enable delivering Multicast packets originating
from a specific source address defined in the next field.
•
SSM IPv6 Access List—Define the list containing source addresses from which to
deliver Multicast packets:
-
Default list—Defines the SSM range access list to FF3E::/32.
-
User defined access list—Select the standard IPv6 access list name defining the
SSM range. These access lists are defined in
Click Apply. The Running Configuration file is updated.
To add protection to a VLAN, click Add and enter the following fields:
•
Upstream Interface—Select the outgoing interface.
•
Downstream Interface—Select the incoming interface.
•
Downstream Protection—Select one of the following options:
-
Use Global—Use the status set in the global block.
-
Disable—This disables forwarding of IPv6 Multicast traffic from downstream
interfaces.
-
Enable—This enables forwarding from downstream interfaces.
The following fields are displayed for each IP Multicast route:
•
Source Address—Unicast source IPv4 address.
•
Group Address—Multicast destination IPv4 address.
•
Incoming Interface—Expected interface for a Multicast packet from the source. If the
packet is not received on this interface, it is discarded.
•
Outgoing Interfaces—Interfaces through which packets will be forwarded.
•
Uptime—Length of time in hours, minutes, and seconds that the entry has been in the
IP Multicast routing table.
Access
Lists.
14
258
Hide quick links:
Advertisement
Table of Contents
