Cisco SX350 Series Administration Manual page 233

Managed switches

Hide thumbs Also See for SX350 Series:

Table of Contents

Auto Smartport—Auto Smartport waits for a device to be attached to the interface

before applying a configuration. When a device is detected from an interface, the

Smartport macro (if assigned) that corresponds to the Smartport type of the attaching

device is automatically applied.

The Smartport feature consists of various components and works in conjunction with other

features on the device. These components and features are described in the following sections:

Smartport, Smartport types and Smartport macros, described in this section.

Voice VLAN and Smartport, described in the

LLDP/CDP for Smartport, described in the

sections, respectively.

Additionally, typical work flows are described in the

What is a Smartport

A Smartport is an interface to which a built-in (or user-defined) macro may be applied. These

macros are designed to provide a means of quickly configuring the device to support the

communication requirements and utilize the features of various types of network devices. The

network access and QoS requirements vary if the interface is connected to an IP phone, a

printer, or a router and/or Access Point (AP).

Smartport Types

Smartport types refers to the types of devices attached, or to be attached to Smartports. The

device supports the following Smartport types:

IP Phone+Desktop

Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

Discover - LLDP

Discovery - CDP

Common Smartport Tasks

Show Quick Links

Table of Contents