Table of Contents
Advertisement
20
STEP 2
STEP 3
STEP 4
STEP 5
357
-
Status—Displays whether Ingress Rate Limit is enabled.
-
Rate Limit (KBits/sec)— Displays the ingress rate limit for the port.
-
%— Displays the ingress rate limit for the port divided by the total port bandwidth.
-
CBS (Bytes)—Maximum burst size of data for the ingress interface in bytes of data.
•
Egress Shaping Rates:
-
Status—Displays whether Egress Shaping Rates is enabled.
-
CIR (KBits/sec)—Displays the maximum bandwidth for the egress interface.
-
CBS (Bytes)—Maximum burst size of data for the egress interface in bytes of data.
Select an interface, and click Edit.
Select the Port or LAG interface.
Enter the fields for the selected interface:
•
Ingress Rate Limit—Select to enable the ingress rate limit, which is defined in the field
below.
•
Ingress Rate Limit (Kbits per sec)—Enter the maximum amount of bandwidth
allowed on the interface.
The two Ingress Rate Limit fields do not appear when the interface type is LAG.
NOTE
•
Ingress Committed Burst Size (CBS)—Enter the maximum burst size of data for the
ingress interface in bytes of data. This amount can be sent even if it temporarily
increases the bandwidth beyond the allowed limit. This field is only available if the
interface is a port.
•
Egress Shaping Rate—Select to enable egress shaping on the interface.
•
Committed Information Rate (CIR)—Enter the maximum bandwidth for the egress
interface.
•
Egress Committed Burst Size (CBS)—Enter the maximum burst size of data for the
egress interface in bytes of data. This amount can be sent even if it temporarily increases
the bandwidth beyond the allowed limit.
Click Apply. The bandwidth settings are written to the Running Configuration file.
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
Quality of Service
General
Hide quick links:
Advertisement
Table of Contents
