Cisco SX350 Series Administration Manual page 687

Smart Network Application (SNA)
Operations
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
To display this information double-click on a connection until it becomes thick and then click
a second time, to display the following information:
For each link in the connection, the following basic information is displayed:
•
The interface names of the interfaces on both sides of the link
•
The LAG name (if any) on both sides of the link
•
The speed of the link
This information about interface names and LAG membership is only available on the sides of
the connection that belong to SNA-capable devices. If one of the sides of the connection is not
a switch, its ports are not displayed.
The specific links in the explorer are also affected by the active overlay, changing the visual
display of the link according to its status relevant to the selected overlay. See Overlays.
When selecting a link in the connection explorer, the interfaces anchoring the link on both
sides are selected.
Client Explorer
This explorer enables viewing information about selected clients in a client group, such as a
group of IP phones.
This explorer is comprised of a table with a row for each device in the client group. Some
columns in this table are only displayed when specific overlays are active.
The client explorer is not supported for client groups that are connected to the network through
a cloud.
The following information is displayed in the Client Explorer table:
• Device ID—Known information about the device: its host name, the IP address it
uses to connect to its parent switch and the device's MAC address. Only the available
information is displayed here. There are no placeholders for non-available information.
• Device Type—Type of client device.
• Connected port—The port on the parent switch to which this client is
connected.
29
671