Cisco SX350 Series Administration Manual page 640

Managed switches

Hide thumbs Also See for SX350 Series:

Table of Contents

Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x

Choose whether to restrict the SNMP management station to one address or allow SNMP

management from all addresses. If you choose to restrict SNMP management to one address,

then input the address of your SNMP Management PC in the IP Address field.

Input the unique community string in the Community String field.

Optionally, enable traps by using the

Optionally, define a notification filter(s) by using the

Configure the notification recipients on the

If you decide to use SNMPv3:

Define the SNMP engine by using the

the default Engine ID. Applying an Engine ID configuration clears the SNMP database.

Optionally, define SNMP view(s) by using the

available to a community or group.

Define groups by using the

Define users by using the

Engine ID is not set, then users may not be created.

Optionally, enable or disable traps by using the

Optionally, define a notification filter(s) by using the

Define a notification recipient(s) by using the

Supported MIBs

For a list of supported MIBs, visit the following URL and navigate to the download area listed

as Cisco MIBS:

www.cisco.com/cisco/software/navigator.html

Trap Settings

SNMPv1.2 Notification Recipients

page. Either create a unique Engine ID or use

page, where they can be associated with a group. If the SNMP

Trap Settings

SNMPv3 Notification Recipients

Notification Filter

page. This limits the range of OIDs

Notification Filter

Show Quick Links

Table of Contents