Table of Contents
Advertisement
14
STEP 1
STEP 2
STEP 3
257
MLD VLAN Settings
To configure MLD on a specific VLAN:
Click Multicast > IPv6 Multicast Configuration > MLD VLAN Settings.
The following fields are displayed for each VLAN on which MLD is enabled:
•
Interface Name—VLAN for which MLD information is being displayed.
•
Router MLD Version—Version of MLD router.
•
Query Robustness—Enter the number of expected packet losses on a link
•
Query Interval (sec)—Interval between the General Queries to be used if this device
is the elected querier.
•
Query Max Response Interval (sec)—Delay used to calculate the Maximum
Response Code inserted into the periodic General Queries.
•
Last Member Query Interval (msec)—Enter the Maximum Response Delay to be
used if the device cannot read Max Response Time value from group-specific queries
sent by the elected querier.
•
Multicast TTL Threshold—Enter the Time-to-Live (TTL) threshold of packets being
forwarded on an interface.
Multicast packets with a TTL value less than the threshold are not forwarded on the
interface.
The default value of 0 means all Multicast packets are forwarded on the interface.
A value of 256 means that no Multicast packets are forwarded on the interface.
Configure the TTL threshold only on border routers. Conversely, routers on which you
configure a TTL threshold value automatically become border routers.
To configure a VLAN, select it and click Edit. Enter the fields described above.
Click Apply. The Running Configuration file is updated.
MLD Proxy
To configure MLD Proxy:
Cisco Sx350, SG350X, SG350XG, Sx550X & SG550XG Series Managed Switches, Firmware Release 2.2.5.x
Multicast
IPv6 Multicast Configuration
Hide quick links:
Advertisement
Table of Contents
