Configuration File Examples - Panasonic KX-TGP700 Administrator's Manual

2.5 Configuration File Examples

•
The parameters have no order.
•
If the same parameter is specified in a configuration file more than once, the value specified first is
applied.
•
All configurable settings can be specified in the configuration file. You can ignore settings that already
have the desired values. Only change parameters as necessary.
•
Boolean parameters (BOOLEAN) accept all of the following configurations.
"Y": "Y", "y", "Yes", "YES", "yes"
"N": "N", "n", "No", "NO", "no"
Parameter Extensions
You can use parameter extensions to specify parameters as Read-Only or Carrier Default.
Read-Only Specification
•
When "?R" or "?r" is specified, the phone user interface and Web user interface for the parameter in
question is restricted to Read-Only.
* Restricting the phone user interface to Read-Only
The Read-Only parameter settings menu appears, but an error occurs during registration.
* Restricting the Web user interface to Read-Only
The Read-Only parameter settings menu appears grayed out and nothing can be entered.
Note
•
Parameters that can be configured from the device and from the Web can be confirmed from
footnotes 1-3 on the parameter names in "4.1 Configuration File Parameter List".
•
When "?R" or "?r" is not specified, the phone user interface and Web user interface are both readable
and writable.
* Optional specifications for "?R" and "?r" are enabled when the last parameter in question is configured.
Carrier Default Specification
•
When "?!" is specified, applicable parameter values are managed as carrier default values when applied
to operational information.
* Carrier default values are applied once a reset to carrier defaults is executed. Carrier defaults will also
be initialized when a reset to device defaults is executed.
* Once "?!" is specified, the parameter in question will be designated as a carrier default even if said
parameter is configured without "?!". (This setting will remain in place until restored to factory default.)
Specification of Multiple Parameter Extensions
•
One parameter can be assigned multiple extensions.
Example: XXX?R?!="" / XXX?!?r=""
Parameter Extension Configuration Example
1. In the configuration file, set IP Addressing Mode to IPv4 and Read-Only
Example parameter: IP_ADDR_MODE?R="0" ("0": IPv4)
2. If an error occurs when attempting to set the IP Mode to IPv6, see To configure IP Mode (IPv4, IPv6,
IPv4&IPv6) in Configuring the Network Settings of the Unit.
2.5 Configuration File Examples
The following examples of configuration files are provided on the Panasonic Web site (→ see Introduction).
•
Simplified Example of the Configuration File
42 Administrator Guide Document Version: 2020-04