Install The Load Sense Hoses - Raven SmarTrax Installation Manual

Connect the 9/16" JIC F straight end of the supplied hose (P/N 214-1000-135) to the tee fitting and route to
4.
the steering orbitrol.
Note:
Use a supplied 9/16" JIC M/F 90° elbow fitting (P/N 333-0012-042) if necessary.
Disconnect the existing left steer line from the steering orbitrol and connect the 3/4" JIC (F) 90° end of the
5.
directly to the left steer port on the orbitrol.
Trace and remove the existing left steer hydraulic hose previously connected to the steering orbitrol. This
6.
hose will not be needed to complete the SmarTrax installation.
Left and Right Steer Cylinder Connection
FIGURE 7.
Connect the straight 9/16" JIC end of the supplied hose (P/N 214-1000-139) to the existing tee fitting on the
7.
left steering cylinder and route the 90° end to the SmarTrax valve.
Note:
Use a supplied 9/16" JIC M/F 90° elbow fitting (P/N 333-0012-042) if necessary.
Connect to the tee fitting installed in the 'A' port.
8.
Repeat this procedure to connect the right steer hoses (P/N 214-1000-135 & 214-1000-139) to the 'B' port
9.
on the SmarTrax valve.

Install the Load Sense Hoses

Locate and disconnect the load sense hose on the side of the steering orbitrol.
1.
Connect the supplied hose (P/N 214-1000-460) to the load sense port on the steering orbitrol and route to
2.
the 'LS-STEER' port on the SmarTrax valve using the 9/16" JIC M/F 45° elbow fitting if necessary.
Trace the existing hydraulic hose previously connected to the load sense port of the steering orbitrol and
3.
remove the hose from the load sense port on the priority valve. This hose will not be needed to complete
the SmarTrax installation.
Manual No. 016-0190-085
Hydraulic Connections
15