Install The Load Sense Hose - Raven SmarTrax Installation Manual

Install the Load Sense Hose

Load Sense Hoses Installed
FIGURE 10.
Load Sense
Tee Installed
John Deere
Power Beyond
Hose
Install the John Deere Power Beyond plate orifice fitting in the female end of a -6 ORFS M/M/F swivel run
1.
tee adapter fitting (P/N 333-0012-069).
Install the end of the tee fitting containing the orifice on the male end of the installed tank tee fitting.
2.
Install a -6 ORFS M/F 90° swivel elbow fitting (P/N 333-0012-065) on the straight end of the installed tee
3.
fitting.
Trace the Power Beyond hose from the Power Beyond quick coupler to the LS port of the machine's
4.
hydraulic valve.
Disconnect the Power Beyond hose from the LS port.
5.
Remove the existing tee adapter fitting in the LS port.
6.
Important:
Do not remove the Power Beyond straight adapter fitting, the spacer, or the shuttle from the LS port of
the machine's hydraulic valve. These fittings are needed for the SmarTrax load sense hose installation.
Connect the Power Beyond hose to the elbow fitting installed in step 3.
7.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-833) to the 90° end of the installed tee
8.
fitting.
Connect the 90° end of the installed hydraulic hose to the fitting installed in Port LSPV of the SmarTrax
9.
valve.
Install the straight end of the supplied hydraulic hose (P/N 214-1000-833) on the machine's existing Power
10.
Beyond fittings in the LS port.
Note:
It may be necessary to install a -6 ORFS M/F 90° swivel elbow fitting (P/N 333-0012-065) to
achieve the connection.
Install the 90° end of the installed hydraulic hose to the fitting installed in Port LS STEER of the SmarTrax
11.
valve.
Manual No. 016-4001-006
Hydraulic Installation
Load Sense
Port
Tank Tee
Installed
John Deere
Power Beyond
Orifice Fitting
15