Table 30: Information About Existing Module Diagnostics; Table 31: Information About Existing Channel Diagnostics - WAGO SPEEDWAY 767 Series Manual

WAGO-SPEEDWAY 767
767-5203 Serial Interface (RS-232, RS-422/-485)
Pos : 31.9 /Serie 767 (WAGO-SPEED WAY)/Par ametrieren/I/O-M odule/Parametri erung 767- 5203, - 5204 Gl obal e Di agnosen @ 12\mod_1329213581568_21.doc x @ 88880 @ @ 1

Table 30: Information about existing module diagnostics

Global Diagnostics
Diagnostics
Low voltage U
Low voltage U
Pos : 31.10 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung Global e Di agnosen Kurzschl uss /Überlas t und U nterbr echung Fel dversorgung @ 8\mod_1278394655719_21.doc x @ 59061 @ @ 1
Short circuit/ overload
encoder supply
Pos : 31.11 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung Kanaldi agnosen Ü bertemper atur @ 7\mod_1268294869501_21.doc x @ 52378 @ @ 1

Table 31: Information about existing channel diagnostics

Channel Diagnostics
Diagnostics
Overtemperature
Pos : 31.12 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Hinweis/Hi nweis : U nterbrechung S-BU S 48er @ 8\mod_1278393489593_21.doc x @ 59044 @ @ 1
Interruption of the S-BUS
If there is an interruption of the S-BUS, the module is automatically put in STOP
mode. The module outputs are disabled.
Pos : 31.13 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Description
LS
Disabling the outputs
If there is an undervoltage of U
disabled. Machine components can be placed in a dangerous
condition, as well as personnel and machine put in danger.
If an undervoltage of the logic and sensor supply (U
occurs on the module, the outputs are disabled and a corresponding
diagnostic is transmitted to the fieldbus coupler.
The serial interfaces are disabled.
The F-LED of the module illuminates.
A
Disabling the outputs
If there is an undervoltage of U
disabled. Machine components can be placed in a dangerous
condition, as well as personnel and machine put in danger.
If an undervoltage of the actuator supply (U
module, the outputs are disabled and a corresponding diagnostic is
transmitted to the fieldbus coupler.
The serial interfaces are disabled.
The F-LED of the module illuminates.
The module has detected a short circuit or overload of the encoder
supply (only possible when field supply is switched on).
Description
The module has identified overheating on the corresponding channel
(1 – 8) (only enabled when the actuator output is switched on).
Parameterizing
and/or U , the module outputs are
A LS
) of < 18 V
LS
and/or U , the module outputs are
A LS
) of < 18 V occurs on the
A
57