Figure 16: Supply Cable Connected To A Fieldbus Coupler And Modules - WAGO SPEEDWAY 767 Series Manual

WAGO-SPEEDWAY 767
767-5203 Serial Interface (RS-232, RS-422/-485)
Pos : 24.18 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlus s_Spannungs vers orgung allgemein_2 @ 8\mod_1278320131837_21.doc x @ 58967 @ @ 1
To connect the supply cable to the fieldbus coupler and modules, proceed as
follows:
1. Disconnect the power supply from those devices on which you have
mounted the module.
2. Connect the power supply cable (K1) to the
fieldbus coupler and the
For example, if two modules have been connected to the fieldbus coupler,
connect the power supply transmission cable (K1, K2) with the associated
IN and OUT connections, as shown in the following figure.
3. Tighten the plugs and sockets using the knurled-head screws.
4. Screw a protective cap on all unused ports to ensure that IP 67 degree of
protection is provided
Information on connecting the power supply cable (K0) to the "IN" port
a fieldbus coupler can be found in the appropriate manuals.
Pos : 24.19 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlus s_Spannungs vers orgung _4xM 12 - Bild @ 5\mod_1249301804906_21.doc x @ 40067 @ @ 1
6

Figure 16: Supply cable connected to a fieldbus coupler and modules

Pos : 24.20 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Connecting Data and Supply Cables
IN connection (5) of the module.
9
OUT connection (9) of the
5
47
(6) of