Removing The Module From Your System; Removing The Module From The Carrier Rail; Figure 23: Removing The Module (With The Carrier Rail Adapter) From The Carrier Rail - WAGO SPEEDWAY 767 Series Manual

WAGO-SPEEDWAY 767
767-5203 Serial Interface (RS-232, RS-422/-485)
Pos : 52 /Serie 767 ( WAGO-SPEED WAY)/Ser vic e/I/O-M odule/Ser vic e 767- xxxx allgemein 2.2 @ 8\mod_1278649957222_21.doc x @ 59430 @ 3 @ 1
11.2.2

Removing the Module from Your System

To remove the module from your system's framework, proceed as follows:
1. Disconnect the power supply from those devices on which you have
mounted the module.
2. Release the module from your system by unscrewing the M4 screws.
Pos : 53 /Serie 767 ( WAGO-SPEED WAY)/Ser vic e/I/O-M odule/Ser vic e 767- xxxx allgemein 3 @ 5\mod_1249469687968_21.doc x @ 40445 @ 3 @ 1
11.2.3

Removing the Module from the Carrier Rail

In order to keep the representation unambiguous, the carrier rail adapter in the
following figure (B, C) is shown without module.
If the module is mounted on a carrier rail, proceed with the removal as follows:
1. Disconnect the power supply from those devices on which you have
mounted the module.
2. To remove the module, press down the release actuator of the carrier rail
adapter using a slot screwdriver (B) and remove it from the carrier rail (C).
A
Pos : 54 /Serie 767 ( WAGO-SPEED WAY)/Ser vic e/I/O-M odule/Ser vic e 767- xxxx_M12 allgemein2 - Bild @ 5\mod_1249471167718_21.doc x @ 40463 @ @ 1

Figure 23: Removing the module (with the carrier rail adapter) from the carrier rail

Pos : 55 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
B
Service 81
C