Notes About This Documentation; Validity Of This Documentation; Copyright; Tabelle 1: Varianten - WAGO 750-637 Series Manual

WAGO I/O System 750
750-637 Incremental Encoder Interfaces
1

Notes about this Documentation

Always retain this documentation!
This documentation is part of the product. Therefore, retain the documentation
during the entire service life of the product. Pass on the documentation to any
subsequent user. In addition, ensure that any supplement to this documentation
is included, if necessary.
1.1

Validity of this Documentation

This documentation is only applicable to the I/O module 750-637 (Incremental
Encoder Interfaces) and the variants listed in the table below.

Tabelle 1: Varianten

Bestellnummer/Variante
750-637
750-637/000-001
750-637/000-002
750-637/000-003
750-637/000-004
Documentation Validity for Variants
Unless otherwise indicated, the information given in this documentation applies
to listed variants.
The I/O module 750-637 shall only be installed and operated according to the
instructions in this manual and in the manual for the used fieldbus coupler or
controller.
Consider power layout of the WAGO I/O System 750!
In addition to these operating instructions, you will also need the manual for the
used fieldbus coupler or controller, which can be downloaded at www.wago.com.
There, you can obtain important information including information on electrical
isolation, system power and supply specifications.
1.2

Copyright

Notes about this Documentation
Bezeichnung
Incremental Encoder Interfaces
Incremental Encoder Interfaces 24 V/32 Bit
differential
Incremental Encoder Interfaces 24 V/32 Bit single
ended
Incremental Encoder Interfaces RS-422/32Bit/Single
Interpreter
Incremental Encoder Interfaces 24 V/32 Bit single
ended/cam outputs
Public
5
Manual
Version 1.6.1