Output Buffer, Serial Interface; Table 37: Output Buffer, Serial Interface - WAGO SPEEDWAY 767 Series Manual

WAGO-SPEEDWAY 767
767-5203 Serial Interface (RS-232, RS-422/-485)
7.4.2

Output Buffer, Serial Interface

Table 37: Output buffer, serial interface

Parameter
Display mode
Data
Input in ASCII
Input in hexadecimal
Pos : 31.17 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Description
In this box, select the display type for the data. You have the following
options:
- ASCII*
- Hexadecimal
In this box, the data last sent by the control unit to be output by the
interface appears. The display is limited to max. 119 characters.
This box appears if you have selected manual operation for the serial
interface on the Settings page and the display mode is set to ASCII. You
can enter up to 119 characters in this box, which are then transferred to
an attached device independent of the control unit.
If you enter more than the allowed number of characters, a red
exclamation mark appears next to the input box.
This box appears if you have selected manual operation for the serial
interface on the Settings page and the display mode is set to
hexadecimal. You can enter up to 119 characters in this box, which are
then transferred to an attached device independent of the control unit.
If you enter more than the allowed number of characters, a red
exclamation mark appears next to the input box.
In this mode, the individual characters must be separated by a
semicolon. Numbers not preceded by "0x" are interpreted as decimal
characters and automatically converted to hexadecimal display.
Parameterizing 65