Direct Mounting On Your System; Figure 8: Mounting The Module On A Grounded Frame Or To Another Grounding Point - WAGO SPEEDWAY 767 Series Manual

34 Mounting
Pos : 22.10 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Direktmontage 767- xxxx allgemei n_1 @ 5\mod_1249029032515_21.doc x @ 39651 @ 2 @ 1
4.3

Direct Mounting on Your System

Mount the module directly on a level surface of your system, without using
WAGO accessories. Direct mounting of the module is to be carried out as follows:
1. Disconnect the power supply from those devices on which you wish to
mount the module.
2. Mark the drill holes using the hole drilling template printed on the
packaging. You can also hold the module in the desired position and mark
the drill holes. Ensure that there is sufficient space around the 767 Series
components to enable you to connect all cable without problems.
Pos : 22.11 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Hinweis/Hi nweis : 767- xxxx Distanz stüc k @ 8\mod_1279025151416_21.doc x @ 59810 @ @ 1
Direct Mounting
We recommend using WAGO spacers for compact direct mounting. If these are
used, the resulting additional distance from the second 767 Series component is to
be noted. See section "Mounting the Module" > "Mounting the Spacer in the Case
of Compact Arrangement".
Pos : 22.12 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Direktmontage 767- xxxx allgemei n_2 @ 8\mod_1279025380479_21.doc x @ 59813 @ @ 1
3. Fasten the module with two M4x12 screws via the two mounting holes.
Pos : 22.13 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Direktmontage 767- xxxx_4xM 12 - Bil d @ 5\mod_1249284606687_21.doc x @ 39829 @ @ 1

Figure 8: Mounting the module on a grounded frame or to another grounding point

Pos : 22.14 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
767-5203 Serial Interface (RS-232, RS-422/-485)
WAGO-SPEEDWAY 767
Manual
Version 1.1.0