Siemens SIMATIC RF600 Series Configuration Manual page 254

Service and maintenance
13.2 Error messages
AutoId XML/ OPC UA
status LED status
(hex)
5 0x63 Bad
Invalid
Argument /
good
7 0x13 good
7 0xA2 good
8 0xA1 good
9 0x22 good
9 0xA7 good
10 0xE7 good
14 0xE8 good
14 0xE9 good
15 0x61 good
17 -- good
18 0xC1 good
19 0x91 good
254
AutoId
text
REGION_NOT_
FOUND_ERROR
OUT_OF_RANGE_
ERROR
OUT_OF_
RANGE_ERROR
NO_
IDENTIFIER
MULTIPLE_
IDENTIFIERS
MULTIPLE_
IDENTIFIERS
READ_
ERROR
WRITE_
ERROR
WRITE_
ERROR
NOT_SUPPORTED_
BY_DEVICE
DEVICE_NOT_
READY
INVALID_
CONFIGURATION
RF_COMMUNICATION_
ERROR
Error description
All commands:
A parameter of an OPC UA command has an invalid
value.
"ReadTag"/"WriteTag" command:
The addressed memory area is not available in the cur-
rent transponder.
Address error
The address area of the transponder has been exceeded.
Possible causes:
Start address of the command start has been incor-
•
rectly set.
Wrong transponder type
•
The area to be written to is write-protected.
•
The requested data is not available.
There is no transponder with the required EPC ID in the
transmission window or there is no transponder at all in
the antenna field.
More transponders are located in the transmission win-
dow than can be processed at the same time by the
reader.
There is more than one transponder in the transmission
window.
Read access to the transponder failed.
Write access to the transponder failed.
Writing the EPC-ID on the transponder failed.
Unknown command
An uninterpretable XML command was sent to the reader
or the Ident profile sends an uninterpretable command to
the reader.
Possible causes:
The "AdvancedCmd" block was supplied with an in-
•
correct "CMD".
The "CMD" input of the "AdvancedCmd" block was
•
overwritten.
The specified read point is not active because no antenna
was assigned to it.
The specified tag field of the transponder is unknown.
The transponder is not responding.
Configuration Manual, 11/2018, C79000-G8976-C386-07
SIMATIC RF600