Resetreader - Siemens SIMATIC RF600 Series Configuration Manual

Programming via XML interface
10.3 XML commands
Parameter
Parameter
value_id
value_inValue
value_outValue
10.3.2.13

resetReader

This command resets the reader.
After a positive reply from the user application, the reader terminates the TCP/IP connection
and then performs a reset. Following this, you need to establish the connection again with
the user application and restart with the "hostGreetings" command.
166
Type Values
Decimal value 0...4294967295
0...9
Binary characters 0000....
0, 1 1111
Binary characters 0000....
0, 1 1111
Description
Unique command identifier
Each position stands for an input of the
reader:
Inport00: 1st position (least signifi-
•
cant bit right)
Inport01: 2nd position
•
Inport02: 3rd position
•
Inport03: 4th position
•
...
•
Depending on the value of the particu-
lar position, the corresponding input is
set to ON (1) or OFF (0).
If the reader does not support I/O the
value remains empty.
Each position stands for an output of
the reader:
Outport00: 1st position (least signif-
•
icant bit right)
Outport01: 2nd position
•
Outport02: 3rd position
•
Outport03: 4th position
•
...
•
Depending on the value of the particu-
lar position, the corresponding output is
set to ON (1) or OFF (0).
If the reader does not support I/O the
value remains empty.
Configuration Manual, 11/2018, C79000-G8976-C386-07
SIMATIC RF600