Siemens SIMATIC RF600 Series Configuration Manual page 18

Description
3.2 User-specific procedures
Procedure as Rockwell user
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 22)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 27)" or "Assigning an IP address via DHCP (Page 31)".
3. Configure the reader
You will find information on this in the sections "Configuring with Studio 5000 Logix
Designer (Page 37)" and "Configuring with the WBM (Page 39)".
4. Configure / program reader commands
You will find information on this in the section "Programming via Rockwell controller
(Page 107)".
Procedure as XML user
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 22)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 27)".
3. Configure the reader
You will find information on this in the section "Configuring with the WBM (Page 39)".
4. Program reader commands
You will find information on this in the section "Programming via XML interface
(Page 137)".
Procedure as an OPC UA user
1. Connect the hardware
You will find information on this in the section "Connect the hardware (Page 22)".
2. Assign the IP address / device name
You will find information on this in the section "Assigning the IP address / device name
with the PST (Page 27)".
3. Configure the reader
You will find information on this in the section "Configuring with the WBM (Page 39)".
4. Program reader commands
You will find information on this in the section "Programming via the OPC UA interface
(Page 227)".
18
Configuration Manual, 11/2018, C79000-G8976-C386-07
SIMATIC RF600