Introduction; Intended Use - SaMASZ KW 141 Operator's Manual

2. INTRODUCTION

This operator's manual should be considered the machine's basic equipment and should be kept
❑
for further reference. If the machine is handed over to another user, it should be serviceable, and
include this operator's manual, CE declaration of conformity and its required basic equipment.
Before operating the machine its user must familiarize himself with this manual as well as current
❑
work safety rules.
The machine is manufactured according to international safety rules.
❑
Respecting recommendations herein shall ensure use safety.
❑
Should you have any questions relating to the operation and service of the machine, please contact
❑
the manufacturer.
When operating the machine warnings and safety rules marked with this sign
NOTE:
Operating the machine without reading the contents of the manual, and by unauthorized
personnel, children in particular, is strictly forbidden.

3. INTENDED USE

The extension arm can be equipped with mowing heads offered by the SaMASZ co. Machine are
designed for treatment of land drainage ditches in particular as well as mowing of road shoulders,
shredding thinner, small shrubs, weeds, etc. of moderate concentration as well as mowing road
shoulders, slopes, counter-slopes and ground at tractor's right side. Moreover the mower can be used
to trim hedges both in vertical and in horizontal position. Extension arms work properly on grass (and
other plants) with height up to 1.0 m.
Extension arms are mounted on tractors of adequate power (Tab. 1, Tab. 2, Tab. 3). Mounting
the arm is performed on rear 3-point linkage, with which are farming tractors equipped as standard.
Rear PTO must be set on 540 rpm (upon special order 1000 rpm). When operating a tractor with 1000
rpm PTO shaft adjust the rpm so that the shaft rotates at 540 rpm. Thus the operation becomes
economic.
CAUTION!
With such setting make sure the PTO shaft rpm is no higher than 540 rpm.
WARNING!
Do not use the machine for purposes other than those listed in this manual.
Otherwise it will be classified as misuse and could release the manufacturer
from responsibility for any damages. The machine should be used, serviced and
repaired only by personnel familiar with its characteristics and with safety
regulations. Tampering with the machine may release the manufacturer from
responsibility for any resulting malfunctions or damages.
CAUTION!
Basing on experience, upon driving onto single shrub with section up to approx.
1 in / 2 cm, the tractor should be stopped for a while, until the machine shreds
the shrub at the ground, and then slowly with intervals drive forward, so there
occurs no cutterbar locking .
6
KWT, CAMEL, KOLIBER, KW, LAMA
GENERAL PRECAUTION
herein should be respected.
REAR EXTENSION ARMS OPERATOR'S MANUAL