Operating Service; Removing Clogging And Jams; Daily Maintenance - SaMASZ KW 141 Operator's Manual

OPERATOR'S MANUAL
For manual adjustment of the indicator please loosen the plug (Fig. 65). Then using an electrical
cable connect (bridge) adequate ends (Fig. 66) - for temperature sensor failure, end 3 and T, and for oil
level sensor failure, end 1 and 2.
CAUTION!
Follow the above procedure only in an emergency, and therefore do not apply it
for normal extension arm operation.

6.8. Operating service

6.8.1. Removing clogging and jams

When operating the mower pay attention to variable conditions on field, which may influence the
mower clogging, such as: terrain unevenness, height and density of grass as well as other objects in
the grass. In order to avoid clogging, mowing speed should be adjusted to the mentioned conditions.
In order to remove the machine clogging, lower the cutting set onto the ground, disconnect the
drive, take ignition key off and pay particular attention, remove excess material using sharp tool.
After clearing the machine check if nothing has been damaged. When eliminating any clogging on the
machine, use also safety means for operator, so protective gloves and tight wear, due to the risk of
injury, abrasion or damage of skin.

6.8.2. Daily maintenance

Upon daily completion of operation the following should be performed:
remove grass and mud from the machine, etc., (pay particular attention to cutterbar, flail shaft,
❑
adapting shaft and engine guard),
REAR EXTENSION ARMS KWT, CAMEL, KOLIBER, KW, LAMA
Fig. 65. Column oil level and temperature indicator
Fig. 66. Connection diagram
Oil level
57