Operating Hydraulics; Oil Tank With Equipment - SaMASZ KW 141 Operator's Manual

IMPORTANT!
Flail knives must be replaced in pairs.
Worn-out bolts securing the flail blades should be unconditionally replaced. It is forbidden to use
bolts with a lower strength class than 10.9.
Prior to entering hands or any other tools to casing of the cutterbar follow the below advice:
wait until the rotor is stopped,
❑
lower the machine's cutterbar onto the ground,
❑
disconnect the tractor's engine, take ignition key off, lock valves at oil tank,
❑
wear protective gloves and clothing as required by safety precautions.
❑
6.5.

Operating hydraulics

Condition of hoses and hydraulic fittings should be examined periodically and in case of finding
damages replaced with new ones. Irrespective of the above hydraulic hoses should be replaced with
new ones every 5 years taking their storing period into consideration. In winter idle period it is
recommended to store the machine in dry, well vented room, paying attention the hydraulic hoses are
not deflected.
CAUTION!
Oil used in hydraulic circuits is toxic. Prior to performing any servicing, oil
replacement, the operator should wear protective clothing.
Strictly follow the binding provisions on hazardous waste. Used oils should be
drained to special containers and then taken to

6.5.1. Oil tank with equipment

Tightness of tank's (1) welded joints should be examined as well as hoses connections. These
activities should be performed at least once a month (Fig. 54).
50
KWT, CAMEL, KOLIBER, KW, LAMA
2
Fig. 54. Oil tank
REAR EXTENSION ARMS
a nearby oil treatment plant
3
4
OPERATOR'S MANUAL
.
1