Operating Parts; Pto Shaft - SaMASZ UNO 410 Operator's Manual

When mounting slings, chains, handles etc. always pay attention to setting the machine's center
❑
of gravity properly.
To catch machines, pick ropes of adequate length, so that the angle between them is no greater
❑
than 120°, and the angle between the strand and the vertical is no greater than 60°.
To lift the rake, use only lifting devices with hoisting capacity bigger than the rakes weight provided
❑
on data plate. It also concerns ropes and chains used for lifting.
Collapsible elements should be locked in transport position.
❑
When relocating the rake onto another vehicle, there should be no unauthorized personnel permitted
❑
to remain within the danger area.
The rake should be protected from shifting on the vehicle's trailer.
❑
NOTE:
Securing manouvering area and transport of the mower is the responsibility of
a person who does it.
Tab. 3. Location of centre of gravity
Dimension [mm]
A
B

4.5. Operating parts

Prior to operating the rakes check the rotor and the tine condition.
❑
Worn or damaged tines should be replaced immediately with new ones.
❑

4.6. PTO shaft

Prior to operating learn instructions given by the shaft's manufacturer found on the shaft.
❑
Use only the rake's manufacturer recommended PTO shafts.
❑
In order to operate safely use only fit, undamaged telescopic articulated shafts. Damaged
❑
telescopic articulated shaft shall be repaired or replaced with new one.
Pay particular attention to PTO shaft's guards and rake's and tractor's spline shaft guards. Never
❑
work with damaged guards.
Before operation, check all guards (in tractor, machine and the shaft), if they are in place and are
❑
functional. Any worn or damaged guard must be replaced. Damaged or missing guard of drive shaft
may cause serious accident and even death.
10
UNO
Fig. 4. Location of centre of gravity
Uno 410
70
2700
ROTARY RAKE
Model
Uno 440
100
2760
OPERATOR'S MANUAL
Uno 470
70
3050