Parking Brake Lever; Safety Mechanisms; Warning Mechanisms; Warning Buzzer - Baroness GM2810A Owner's Operating Manual

Parking Brake Lever

Caution
Never park the machine on a slope.
Important
Be sure to release the parking brake before
driving.
It may result in the brakes or hydraulic system
malfunction.
The parking brake lever is located to the left of
the front cover.
When parking, link the left and right brake
pedals by using the pedal link bar, depress both
brake pedals, and then pull the parking brake
lever completely.
To release the parking brake, depress the brake
pedals.
1

Parking Brake Lever_001

1 Brake pedals
2 Parking brake lever

Safety Mechanisms

This machine features a safety device for
starting/stopping the engine.
1. As for starting the engine, the safety device
prevents the engine from starting unless it
meets each of the following four conditions.
An operator is sitting on the seat.
･
The parking brake is applied.
･
･ The knife rotation switch is set to the "Stop"
position.
･ The traveling pedal is set to the neutral
position.
Parking Brake Lever
Description of Functions
Important
When you restart the engine after the safety
device stops the engine, be sure to return the
ignition key to the "OFF" position first, and
then restart it.
Otherwise the engine does not start.
2. In the event the operator leaves the seat with
the parking brake applied and the engine
running, the safety device will be activated
and will stop the engine under any of the
following conditions:
The traveling pedal is not set to the neutral
･
position. (The operator has depressed the
traveling pedal.)
The knife rotation switch is set to the
･
"Rotation" position.

Warning Mechanisms

Warning Buzzer

2
Important
When the buzzer (intermittent tone) sounds,
be sure to stop operation since the engine is
overheated.
Do not stop the engine without idling. Allow
the engine to cool down, first. Keep the engine
idling for about 5 minutes before stopping.
Remove dust that is jamming in the radiator,
wd1fww-001 air cleaner, and etc.
This machine features warning mechanisms for
overheating, the hydraulic oil and the engine.
1. Overheat Warning Buzzer
If the engine water temperature exceeds 110
°C (230 °F), a buzzer will sound. (intermittent
tone)
When the buzzer sounds, stop the engine
immediately, and then inspect the machine
and perform any necessary maintenance.
2. Hydraulic Oil Level Warning Buzzer
If the oil level in the hydraulic tank declines
from the specified level by approximately 2.0
3
dm (2.0 L), a buzzer will sound. (continuous
tone)
When the buzzer sounds, stop the engine
immediately, and then inspect the machine
and perform any necessary maintenance.
GM2810A
Page 4-9