Adjusting The Neutral Position Of The Piston Pump; Change Of Fuse - Baroness GM2810A Owner's Operating Manual

GM2810A
Repair
Adjusting the Neutral Position of the Piston
Pump
Caution
Make sure not to touch rotating tires.
Caution
When adjusting the neutral position, pay close
attention to abrupt start of the machine.
Place the jacks beneath the jack-up points,
and then lift the machine until all the tires get
off the ground.
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
1. Stop the engine.
2. Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
3. Make sure that no tires come into contact
with the jack stand.
4. Open the underseat cover.
"Opening and Closing of Underseat Cover"
(Page 5-3)
5. Start the engine, and rev it up to the
maximum rpm.
6. Set the 2WD/4WD selector switch to the
"2WD" position.
7. Adjust the neutral position.
[1] If the front tires rotate forward, loosen the
lock nuts, and then turn the neutral
adjustment rod to shorten it.
[2] If the front tires rotate in reverse, loosen
the lock nuts, and then turn the neutral
adjustment rod to extend it.

Adjusting the Neutral Position of the Piston Pump_002

Page 7-4
3
2
1
hsn2jo-017
1
2
3
8. Find the position where the front wheels
stop, and then tighten the lock nuts.

Change of Fuse

Important
When performing maintenance on the
electrical system, be sure to remove the
negative battery wire.
Important
If a fuse blows, a short may have occurred
within the electrical circuit.
Check for the cause, such as faulty terminal
connections, damaged wiring or terminals, or
incorrect wiring.
Important
For fuse replacement, clean the fuse
mounting area with use of compressed air
before mounting the fuse.
Fuse Box
The fuse box includes spare fuses and tools.
1
The machine uses a mini fuse for
automobiles.
Replace an old fuse with a new fuse of the
specified capacity.
Adjustment and Replacement
Lock nut A (Left-hand thread)
Neutral adjustment rod
Lock nut B (Right-hand thread)
pkm25s-010
Fuse Box_001
Fuse box
1