Dpf Auto Regeneration Inhibit Switch - Baroness GM2810A Owner's Operating Manual

GM2810A
Description of Functions

DPF Auto Regeneration Inhibit Switch

Caution
Normally, set the DPF auto regeneration
inhibit switch to "Auto regeneration mode".
However, when operating in a location where
fires may occur, set the DPF auto
regeneration inhibit switch to "Auto
regeneration inhibit mode".
Important
The DPF auto regeneration inhibit switch is
reset to "Auto regeneration mode" when the
engine is started even if the engine was
stopped with the DPF auto regeneration inhibit
switch set to "Auto regeneration inhibit mode".
Important
In "Auto regeneration inhibit mode" any DPF
regeneration of "Auto regeneration", "Parked
regeneration" and "Manual regeneration" is
inhibited.
For DPF regeneration, deactivate "Auto
regeneration inhibit mode".
The DPF auto regeneration inhibit switch is
located in the operation panel.
The DPF auto regeneration inhibit switch is the
switch for shifting between "Auto regeneration
mode" and "Auto regeneration inhibit mode".
With the engine running, press this switch to
shift between "Auto regeneration mode" and
"Auto regeneration inhibit mode".
Auto regeneration mode:
･
The DPF auto regeneration inhibit switch is
reset to "Auto regeneration mode" when the
engine is started.
In "Auto regeneration mode" regeneration is
automatically performed regardless of the
main vehicle's travel and stop on the condition
that a specific amount of PM is accumulated
and the requirements for DPF regeneration
are fulfilled.
Auto regeneration inhibit mode:
･
In order to set to "Auto regeneration inhibit
mode", press the DPF auto regeneration
inhibit switch after the engine is started.
Page 4-4
In "Auto regeneration inhibit mode" PM
accumulates in the DPF and PM
accumulation level increases.
Unless the operator implements regeneration
on his own will, regeneration is not performed.

DPF Auto Regeneration Inhibit Switch_001

1 DPF auto regeneration inhibit switch
When the DPF auto regeneration inhibit switch
is pressed and set to "Auto regeneration inhibit
mode", the monitor displays Auto regeneration
inhibit icon.
0 RPM
ENG RPM
25 C
COOL TEMP
DPF Auto Regeneration Inhibit Switch_002
1 Auto regeneration inhibit icon
DPF Auto Regeneration Inhibit Switch
1
jvex95-009
1
80 %
% SOOT
55 %
FUEL LEVEL
jvex95-004