Riso ComColor Series User Manual page 104

2 Copy
●
Configuring the Slip Sheet Setting
Insert a slip sheet between sets or jobs.
■ Slip sheet
[OFF]
[Between sets]
Insert a slip sheet between sets, based on the unit
specified in [Collate].
[Between jobs]
Insert a slip sheet between print jobs.
■ Select tray
When selecting [Between sets] or [Between jobs],
select the tray in which [Slip sheet] is loaded.
[Standard tray], [Feed tray1], [Feed tray2], [Feed tray3]
It is recommended that you set [Tray selection] to
[Manual] on the [Feed tray] screen, when using
special paper as slip sheets.
1
Display the [Collate/slip sheet] screen.
Follow Steps 1 and 2 in "Configuring the Collate Setting".
2
Select the position where slip
sheets are to be inserted.
3
Select the feed tray for slip sheets.
Pressing the "Select tray" button will display the
[Select tray] screen.
Select the feed tray that is loaded with slip
sheets, and press [OK].
The slip sheet settings are confirmed and the
[Collate/slip sheet] screen is displayed.
4
Press [OK].
The settings are confirmed and the copy mode
screen is displayed.
2-42
●
Configuring the Offset Output
Setting
This function outputs each printout shifted apart
from one another.
An optional multifunction finisher or face down
offset tray is required to use this setting.
[OFF]
[Between sets]
Stack each collated set shifted apart from one
another.
[Between jobs]
Stack each print job shifted apart from one another.
■ Paper that can be offset
• When using the face down offset tray:
131 mm × 148 mm to 305 mm × 550 mm (5 3/16"
× 5 13/16" to 12" × 21 5/8")
• When using a multifunction finisher:
A3, B4, A4, A4-R, B5-R, Ledger, Legal, Letter,
Letter-R, Foolscap, custom size (203 mm ×
182 mm to 297 mm × 488 mm (8" × 7 3/16" to
11 11/16" × 19 3/16"))
1
Display the [Collate/slip sheet]
screen.
Follow Steps 1 and 2 in "Configuring the Collate
Setting".
2
Select the offset output setting.
3
Press [OK].
The settings are confirmed and the copy mode
screen is displayed.
ComColor Series User's Guide 01