Table of Contents
Advertisement
Assembly Preparation
1. Hook up the In-Row Ripper to a tractor using the
three-point hitch. Raise the unit about 36" and place
stands under the main frame to prevent accidental
lowering.
Do not attempt to lift heavy parts (such as the
frame), manually. Use a hoist or a forklift to move
these parts into position.
Jackstand Installation
1. Remove jackstand(s) from frame.
2. Remove rigid gauge adjustment pin and 3/16 hair pin
from outer jackstand tube.
3. Insert jackstand through bottom of outer jackstand
tube and pin at desired level with rigid gauge
adjustment pin and 3/16 hair pin (See Figure 3-1.)
WARNING
ASSEMBLY INSTRUCTIONS
SMV Bracket Installation
1. Attach the SMV mounting bracket to the center of the
rear frame using u-bolt and 5/8-11 flange head
serrated nuts (See Figure 3-1.)
2. Attach SMV emblem to top of SMV mounting bracket
using 1/4-20 x 1 hex head cap screws, flat washers,
and hex lock nuts (See Figure 3-5.)
Tire and Wheel Assembly
1. All hubs and spindles come already assembled from
the factory. Mount the tire and wheel assembly onto
the hubs.
3-3
Advertisement
Table of Contents
