Connect The Harness To The Autoboom Valve; Connect The Harness To The Sensors - Raven AutoBoom Case IH Patriot 250 Installation Manual

C 6
HAPTER

CONNECT THE HARNESS TO THE AUTOBOOM VALVE

FIGURE 2. AutoBoom Harness Connected to Valve
1. Locate the LEFT PRESS and RIGHT PRESS connectors on the harness cable (P/N 115-0230-073).
2. Route the connectors to the AutoBoom valve (P/N 063-0131-124).
3. Connect the LEFT PRESS connector to Port G1 on the AutoBoom valve.
4. Connect the RIGHT PRESS connector to Port G4 on the AutoBoom valve.
5. Locate the LEFT SOLENOID and RIGHT SOLENOID connectors on the harness cable.
6. Connect the LEFT SOLENOID connector to Port 4A on the AutoBoom valve.
7. Connect the RIGHT SOLENOID connector to Port 4B on the AutoBoom valve.
8. Locate the LEFT PROP and RIGHT PROP connectors on the harness cable.
9. Connect the LEFT PROP connector to Port 5A on the AutoBoom valve.
10. Connect the RIGHT PROP connector to Port 13A on the AutoBoom valve.

CONNECT THE HARNESS TO THE SENSORS

1. Locate the CENTER SENSOR connector on the AutoBoom harness cable (P/N 115-0230-073).
2. Connect the CENTER SENSOR connector to the installed center sensor (P/N 063-0130-012).
3. Locate the LEFT SENSOR (OUTER) connector on the AutoBoom harness cable.
4. Connect the LEFT SENSOR (OUTER) connector to the installed 50' sensor extension cable (P/N 115-0230-050).
5. Locate the RIGHT SENSOR (OUTER) connector on the AutoBoom harness cable (P/N 115-0230-073).
6. Connect the RIGHT SENSOR (OUTER) connector to the installed 50' sensor extension cable.
7. If optional inner boom sensors are installed, repeat the steps above to connect the inner sensors.
28Case IH Patriot 250/2240/2250 & New Holland SP2500 (80'-100' Booms) AutoBoom® Installation Manual