Table of Contents
Advertisement
C
4
HAPTER
CONNECT THE SENSOR CABLES
1. Connect the left sensor cable (P/N 115-0230-050) to the connector on the left sensor.
2. Route the left sensor cable toward the AutoBoom valve.
3. Loop and tie-off any excess cable, allowing enough cable for boom folding and extension.
4. Repeat the steps above to connect the remaining sensor cable(s) (P/N 115-0230-050 or 115-0171-602).
NOTE:
The sensors will be connected to the AutoBoom system in the wiring phase of installation.
24Case IH Patriot 250/2240/2250 & New Holland SP2500 (80'-100' Booms) AutoBoom® Installation Manual
Advertisement
Table of Contents
