Raven FLOWMAX 220 Quick Start Manual

FLOWMAX 220 QUICK START GUIDE
OPERATION
Turn on FLOWMAX 220 by pressing
NOTE: Without activity, FLOWMAX 220 will shut off automatically after 90 seconds. After power down,
depress
METER CAL has been entered at the factory. Changing of the CAL number is required only after field replacement of
display assembly and/or flowmeter.
DISPLAY TITLES
Flow -- Flow Rate will flash (vol/min)
U S - - V o u l m e n i
I S - - V o u l m e n i i l
"690" -- Adjustable Meter Calibration #
(preset at factory)
VOL 1 -- Total Volume #1 gallons [liters]
VOL 2 -- Total Volume #2 gallons [liters]
VOL 3 -- Total Volume #3 gallons [liters]
Depress key to initiate the display. Depress the
Depress key to display Flow Rate in gallons/min [liters/min].

ENTERING DATA
To Clear Volume Totals:
1. Depress
2. Depress
3. Display will flash "CLR V1" (depress
4. Depress
To Enter Meter Cal:
1. Depress
2. Depress
3. Depress
4. Depress
5. Depress
6. Depress
key.
key to re-start FLOWMAX 220. (Flow pulse will not re-start the display).
g a o l l n s
e t s r
key until "VOL1" is displayed.

key.
key (VOL1 will re-set to zero).
key.

key.
key until the METER CAL # is displayed.

key ("C" will appear on the right side of the display).
key to decrease Meter Cal # or depress

key to program adjusted Meter Cal #.
CLR V1 -- Clear Volume 1
C L R V 2 - - C e l
C L R V 3 - - C e l
Lo BAT -- Limited battery life remaining
key to toggle through VOL1, VOL2, & VOL3.

key to toggle between CLR V1, CLR V2, or CLR V3).

key to increase Meter Cal #.

r a V o u l m e 2
r a V o u l m e 3
016-0159-873
SHEET 1 of 2
01/08 REV C