Select a suitable location for the foot switch (P/N 063-0172-470) to be installed.
1.
Note:
The foot switch should be installed in a location where the operator has easy access to it and is
able to fully press the pedal.
Using the holes in the foot switch as a template, drill holes in the floor of the cab.
2.
Secure the foot switch to the floor by installing the supplied screws in each of the mounting holes.
3.
Route the foot switch cable connector toward the SmarTrax node (P/N 063-0173-228) mounting location.
4.
Locate the ENABLE connector on the node harness (P/N 115-4001-196) and connect it to the foot switch
5.
cable connector.
Install the Valve Harness
Valve Cable Routed Through Access Point
FIGURE 20.
Route the valve harness (P/N 115-4001-002) into the cab from the foam access point under the
1.
convenience tray to the right of the seat.
Manual No. 016-4001-127 Rev. B
Cab Component Installation
27